RV Water Pump Silencer Feet - Complete Kit

Stop Waking Up Every Time Someone Uses Water

Your water pump goes from "waking everyone up" to "barely noticeable." Complete vibration isolation from the floor.

What You Get

• 4 rubber isolation feet with screws
• All mounting hardware included
• 15-minute installation
• Works with Shurflo, Flojet, and most RV pumps

Why This Works

Isolates pump vibration from your floor using soft rubber feet with zero hard fastener connections between pump and floor.

Installation (15 minutes)

1. Bolt the threaded plastic adapters to your pump using included 5mm bolts
2. Loosely attach rubber feet to adapters
3. Position pump where it will be mounted and trace around feet with pencil
4. Remove pump, position rubber feet in traced locations
5. Screw feet to floor with included self-tapping screws
6. Slide pump adapters into feet and reconnect lines

For Best Results: Add flexible inlet/outlet hoses (see our video for details). This can be done with two 1/2-in x 1/2-in Threaded MIP (male) union fittings and two ~16" 1/2" FIP to 1/2" FIP (female) faucet connector hoses.

Before You Buy: Confirm your pump is floor-mounted with clearance around it for the feet and room to install.

IMPORTANT: Floor mounting only (gravity retained design). The plastic inserts fit snugly inside the rubber feet, but are not designed to retain the pump if it was wall mounted.

This kit is universal and should work for 'most' RV's. Please locate your pump before purchasing and make sure it is floor mounted and has enough space around it for you to install these feet.