RV Water Pump Silencer Feet - Complete Kit

Stop Waking Up Every Time Someone Uses Water

Your water pump goes from "waking everyone up" to "barely noticeable." Complete vibration isolation from the floor.

Two Options

Feet Only is the four silencer feet plus every adapter and screw you need to mount them. That stops vibration going into the floor. Nothing else to buy for that job.

Feet + Flex Hoses adds the two braided stainless supply lines and two brass nipples you need to also break the path into your rigid plumbing. If your pump is hard plumbed with stiff line running straight into the ports, vibration travels down the water lines and into the wall no matter how well the pump is isolated from the floor. The flex lines fix that. If your pump already has flexible hose on both ports, the feet alone will do it.

What You Get

Feet Only

• 4 rubber isolation feet with screws
• All mounting hardware included
• 15-minute installation
• Works with Shurflo, Flojet, and most RV pumps
• FREE shipping

Feet + Flex Hoses is everything above, plus

• 2 braided supply lines, 16 inch, 1/2" FIP (female) on both ends
• 2 brass close nipples, 1/2" MIP (male) on both ends
• No more trips to the hardware store mid-install
• Still FREE shipping

Why This Works

Isolates pump vibration from your floor using soft rubber feet with zero hard fastener connections between pump and floor. The flex hoses do the same job on the plumbing side, so the pump isn't rigidly tied to anything.

Installation (15 minutes)

1. Bolt the threaded plastic adapters to your pump using included 5mm bolts
2. Loosely attach rubber feet to adapters
3. Position pump where it will be mounted and trace around feet with pencil
4. Remove pump, position rubber feet in traced locations
5. Screw feet to floor with included self-tapping screws
6. Slide pump adapters into feet and reconnect lines

If you got the flex hoses, do this before step 6. Pull the existing fittings off the pump inlet and outlet ports. Thread a brass nipple union onto each RV side hose. Screw a braided line onto each nipple, then connect the other end of each flexible line to the pump. Snug is enough, these are rubber gasket connections and you can crack a fitting by cranking on it.

Here is the video I made on the problem and the fix, including the flex hose part: https://youtu.be/i5RKmdSq9-0

Before You Buy: Confirm your pump is floor-mounted with clearance around it for the feet and room to install. If you want the flex hoses, make sure you have enough room. They can be looped, but don't bend them so far that they kink.

IMPORTANT: Floor mounting only (gravity retained design). The plastic inserts fit snugly inside the rubber feet, but are not designed to retain the pump if it was wall mounted.

This kit is universal and should work for 'most' RVs. Please locate your pump before purchasing and make sure it is floor mounted and has enough space around it for you to install these feet.